In contrast, the type of choice is relatively simple, and accurately provide the conditions of the reducer, master reducer design, manufacture and use of the characteristics of the general reducer is the right choice of the key to the key. Specifications are selected to meet the strength, heat balance, shaft extension to bear the radial load and other conditions.
1. According to the mechanical power or torque selection specifications (strength check)
Hypoid Gear Motor and special reducer design selection method is the biggest difference, the former applies to various industries, but the deceleration can only be designed according to a specific working conditions, so the user needs to be based on their own requirements to consider different correction factors , The factory should be the actual selection of the motor power (not the rated power of the reducer) to nameplate; the latter according to the user's specific conditions designed to consider the coefficient, the design has generally been considered, as long as the use of power to meet the use of less than or equal to slow The rated power of the device can be, the method is relatively simple.
Second, the thermal balance check
The permissible thermal power value of the shaft mounted speed reducer is the maximum equilibrium temperature (typically 85), which is permissible under the conditions of a specific working condition (normal ambient temperature 20 ° C, 100% per hour, continuous operation, 100% power utilization) ° C). Conditions are different when the corresponding coefficient (sometimes integrated into a coefficient) to amend.
3. Check the radial load on the shaft extension
General reducer often must be on the input shaft, the output shaft shaft to allow the middle of the maximum allowable radial load to give restrictions should be checked, should be made to the manufacturer when the increase in shaft diameter and increase the bearing requirements.
没有评论:
发表评论